Worx WG743E Original Instructions Manual page 19

key. Clean the exterior of the machine thoroughly using a soft brush and cloth. Do not use water,
solvents or polishes. Remove all grass and debris, especially from the ventilation slots.
Turn the machine on its side and clean the blade area. If grass cuttings are compacted in the
blade area, remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other objects on top of the machine.
To aid storage, release the Lock Cam Lever, and fold the upper handle as shown in Fig. L1, L2.
ENVIRONMENTAL PROTECTION
Waste electrical products must not be disposed of with household waste. Please recycle where facilities exist.
Check with your local authorities or retailer for recycling advice.
TROUBLE SHOOTING
Problem
1. Mower doesn't run
when bail handle is
activated.
2. Motor stops while
mowing.
3. Mower runs but
cutting performance is
unsatisfactory, or does
not cut entire lawn.
4. Mower is too hard to
push.
Cordless Lawn mower
A. Check to make sure safety key has been installed and is fully
seated and that button on switch housing is being completely
pushed.
B. Release bail handle to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return
to an authorized servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
A. Release bail handle to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return to
an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait for green
light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for
green light to come on.
B. Release Bail handle to turn mower off. Remove safety key. Turn
mower over and check: Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check each
wheel for free rotation.
Solution
19
EN