Table of Contents
Advertisement
The USB power-saving function is valid only when the USB interface communication condition is
set to the vendor-defined class and the system configuration is set so that the USB driver can
support the USB power-saving function.
Release condition of receive buffer BUSY
• Releases when the remaining receive buffer capacity becomes 256 bytes (initial setting)
• Releases when the remaining receive buffer capacity becomes 138 bytes
This function is enabled only when Receive buffer capacity is set to 4KB.
Select paper out detector enabled for paper out signal output
• Roll paper out detector (initial settings)
• Disabled
Error signal settings
• Enabled (initial setting)
• Disabled
Pre-feed before next print
• Disabled (initial setting)
• Enabled
• When using this function, the top margin is approximately 10.5 mm.
• This setting becomes invalid if you change the "Amount of top margin by backfeed" setting from
the initial setting (9.5mm (no backfeed)).
Roll paper near-end detection
• Disabled (initial setting)
• Enabled
Paper width
• 80mm (initial setting)
• 58mm
Chapter 3 Advanced Usage
50
Advertisement
Table of Contents
