Connecting The System - Yamaha E810 Owner's Manual

CONNECTING THE SYSTEM

Make sure you read the following procedure and notes carefully before connecting the system. For information on the
speakers (NX-E800), refer to the owner's manual supplied with it.
Note
Do not connect the power cable of the receiver, DVD player, or other components to the wall outlet until all cable connections are
completed.
Right speaker
(NX-E800)
1 Connect the DVD/CD (L/R) jacks of the receiver to the AUDIO OUT (L/R) jacks of the DVD player using the
supplied audio pin cable.
2 Connect the system connector (TO DVD-E810) jack of the receiver to the system connector (TO RX-E810) jack of
the DVD player using the supplied system control cable.
3 Connect the speaker terminals (L) of the receiver to the speaker terminals of the left speaker and the speaker terminals
(R) of the receiver to the speaker terminals of the right speaker using the speaker cables supplied with the speaker set
(NX-E800). See page 13 for details.
y
• The system control connection is used to synchronize the specific operations between the receiver and the DVD player.
• If you want to connect an amplifier with a digital input instead of the RX-E810, use the DIGITAL OUT (COAXIAL or OPTICAL)
jacks of the DVD player and configure the "DIGITAL OUTPUT" setting in the setup menu (see page 52).
12
En
Connecting the System
3
ANTENNA SPEAKERS
75
UNBAL.
DOCK 6 MIN / SPEAKER
FM
DVD/CD
R
GND
IN
TAPE/MD
OUT
AM
AUX
R L
1
MAINS
S VIDEO
Left speaker
3
AC OUTLETS
SWITCHED
L
SUBWOOFER TO DVD-E810
OUT
100W MAX. TOTAL
AV
VIDEO OUT DIGITAL OUT AUDIO
OUT
COMPONENT
L
P Y
R
COAXIAL OPTICAL
VIDEO P R
B
(NX-E800)
MAINS
Receiver (RX-E810)
(Europe model)
2
TO RX-E810
DVD player (DVD-E810)