Download
Share
Print this page
Ingersoll-Rand HXAX Series Maintenance Information
  1. Manuals
  2. Brands
  3. Ingersoll-Rand Manuals
  4. Grinder
  5. HXAX Series
  6. Maintenance information
Ingersoll-Rand HXAX Series Maintenance Information

Ingersoll-Rand HXAX Series Maintenance Information

Air grinder
Hide thumbs Also See for HXAX Series:
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
16575938
Edition 1
May 2006
Air Grinder
Series HXAX
Maintenance Information
Save These Instructions

Advertisement

loading
Need help?

Need help?

Do you have a question about the HXAX Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Ingersoll-Rand HXAX Series

Summary of Contents for Ingersoll-Rand HXAX Series

  • Page 1 16575938 Edition 1 May 2006 Air Grinder Series HXAX Maintenance Information Save These Instructions...
  • Page 2 WARNING • Always wear eye protection when operating or performing maintenance on this tool. • Always turn off the air supply and disconnect the air supply hose before installing, removing or adjusting any accessory on this tool, or before performing any maintenance on this tool. Note: When reading the instructions, refer to exploded diagrams in Parts Information Manuals when applicable (see under Related Documentation for form numbers).
  • Page 3 5. If the Front Rotor Bearing (20) must be replaced, support Disassembly of the Inlet and Throttle the Front End Plate (17) between two blocks on the table 1. Using a 15/16” wrench six point socket, unscrew and of an arbor press. Place the blocks as close to the body remove the Inlet Assembly (1).
  • Page 4 8. Inject approximately 1 cc of Ingersoll Rand No. 68 Support the machined face of the Angle Head (36) on Grease into the small recess at the bottom of the motor the table of an arbor press with the upper arbor housing bore.

  • Page 5: Troubleshooting Guide

    10. Thoroughly clean the small threads on the Arbor above the 20 and 25 ft-lb (27 and 34 Nm) torque. This is a left-hand Bevel Gear and the threads in the Bevel Gear Nut (42). thread, turn counterclockwise to tighten. 11.

  • Page 6: Related Documentation

    Trouble Probable Cause Solution Dirt accumulation on Throttle Valve or Disassemble, inspect and clean parts. Throttle Valve Seat Worn Throttle Valve or Throttle Valve Replace the Throttle Valve and/or Throttle Valve Seat. Seat Leaky Throttle Valve Excessive dirt build-up beneath the Clean out the slot area.
  • Page 7 Notes...
  • Page 8 www.irtools.com Ingersoll Rand © 2006 Company...