Manual Tape-Programming - Yamaha 480 Owner's Manual

Manual tape-programming

This is for recording desired tracks in any desired order onto a tape.
1
Follow steps 1 – 4 on page 15.
2
PROG
3
Select the track numbers (to be recorded on side A) in
the desired order.
* Programmed track numbers are illuminated on the
display. You can select a track which can be
programmed for the remaining time of (the side of) the
tape from track numbers flashing on the display, but you
cannot select any darkened track number.
4
When track selection for side A is finished, press the
TAPE button.
A pause mode is programmed.
Notes on tape programming
•
To check, cancel or correct program data, refer to page 14.
* In checking the program data, note that "Pu" appears
between track numbers for side A and side B.
•
Up to a maximum of 25 tracks can be programmed. If,
however, the PAUSE mode is inserted, it is counted as one
track.
16
2
7
PROGRAM
A TOTAL
REMAIN
1 2 3 4 5 6 7 8 9 10 11 12
+
1 2 3 10
4
5 6
7 8 9 0
TAPE
OPEN/CLOSE DIMMER TIME
4
PROG TAPE CLEAR PEAK
SPACE S/F RANDOM
REPEAT
+
1 2 3 10
3, 5
4 5 6
7 8 9 0
6, 7
SKIP PAUSE PLAY
SEARCH INDEX
STOP
+
–
OUTPUT LEVEL
SYNCHRO
5
Select the track numbers (to be recorded on side B) in
the desired order.
6
Begin recording on the tape deck and press the PLAY
button on this unit at the same time.
7
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording and,
at the same time, press the PLAY or PAUSE button on
this unit.
Notes
•
If, in step 3 or 5, "E rr" appears in the display, the track
number just selected cannot be programmed because there
is not enough time remaining on the tape. However, at this
time, if any other track number is flashing continuously in the
display, you can program it instead of the unprogrammable
one.
•
In step 3 or 5, each time a selection is made, the track
number and the tape's remaining time will be displayed, and
then the display will change to indicate the number of the
next program.
•
CD synchronized recording function can be used if your tape
deck is compatible with it. In this case, in step 6 and 7, press
the SYNCHRO button and then press the PLAY button on
this unit's remote control transmitter. Recording
automatically begins. (For details, refer to page 19.)
•
This function can be used to program up to track number 24.
If the disc has more than 24 tracks, track number 25 and
thereafter will not be programmed.
+
1 2 3 10
4 5 6
7 8 9 0