Manual Tape Programming - Yamaha CDC-835 Owner's Manual

Manual tape programming

This is useful for recording desired tracks selected from one or several discs in any desired order onto tape.
1
Follow step 1, 4 and 5 on page 17.
2
PROG
3
If necessary, select the desired disc.
4
If necessary, select any desired DEQ-mode.
5
Select the desired track.
+
10 1 2 3
6
Repeat step 3–5 to set more programs for the side A
of the tape. You can select the same track again.
* If "E rr" appears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
7
After you finish the programming for the side A,
program the pause mode by pressing the TAPE
button.
* "Pu" flashes in the display, and after then you can begin
programming for side B.
18
Flashes on and off.
4 5 6 7 8 9
TAPE
2 7 5
8
Follow step 3–5.
9
Repeat step 3–5 to set more programs for the side B
of the tape.
You can select the same track again.
* If "E rr" appears in the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
10
Begin recording on the tape deck and press the
PLAY/PAUSE button on this unit at the same time.
11
The unit will pause at the end of side A of the tape.
Turn the tape over to side B. Resume recording
and, at the same time, press the PLAY/PAUSE
button on this unit.
Notes
0
If you will program tracks from more than one disc, before
you press the PROG button, check the total recorded time of
each disc on the disc tray by pressing the DISC SKIP button
in turn. Without this operation, the total remaining time of
each side of the tape and previously programmed track
numbers (and also unprogrammed track numbers) will not
be displayed during programming.
In step 6 and 9, even if "E rr" appears in the display, you can
program another track of which time is shorter than the
remaining time on the side of the tape. In this case, you can
check the remaining time on the side of the tape by pressing
the TIME display mode-select button.
Notes on tape programming
To check, cancel or correct program data, refer to page 13.
The maximum number of tracks that can be programmed is
40. If, however, the PAUSE mode is inserted, it is counted
as one track.
This function can be used to program up to track number 20.
If the disc has more than 20 tracks, track number 21 and
thereafter will not be programmed.
10,11
3
4