Hisense HMO173SR Use And Care Manual page 4

 Do not cover or block any openings on the appliance.
Do not store or use this appliance in outdoor places. Do not use this product at

places where it can get wet, such as near a kitchen sink, in a wet basement, near
a swimming pool, or in similar locations.
 Do not operate this appliance if it has a damaged cord or a plug, if it is not
working properly, or if it has been damaged or dropped.
Do not immerse the cord or plug into water. Keep the cord away from heated

surfaces. Do not let the cord hang over edge of table or counter.
 Use only thermometers that are specifically designed for use in microwave
ovens.
 Do not operate any heating or cooking appliance beneath this appliance.
 Make sure the glass turntable and roller rings are in place when you operate the
oven.
 This appliance should be serviced only by qualified personnel. Please call the
Hisense Customer Care number for any service issues.
 When cleaning the door seals, use only mild, nonabrasive soaps or detergents
applied with a sponge or soft cloth.
 VENTILATING HOODS
-
Clean ventilating hoods frequently. Grease should not be allowed to
accumulate on the hood or filter.
-
When cooking foods below the oven, turn the fan on.
 This appliance is suitable for installation above either gas or electric ranges.
 This equipment has been tested and found to comply with Part 18 of the FCC
Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. CAUTION: Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the
product.
This equipment generates radio frequency energy and if not installed and used

in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, try to correct the interference
using one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Plug the equipment into a different outlet or circuit than the receiver.
-
Consult the dealer or an experienced radio/TV technician.
4