C4. Mount The Microwave Oven - Hisense HMO173SR Installation Instructions Manual

C4 .
MOUNT THE MICROWAVE OVEN
Do not grip or use handle during installation.
IMPORTANT:
If filler blocks are not used, case damage may occur from over tightening screws.
If your cabinet is metal, use the nylon grommet around the power cord hole to prevent cutting of the cord.
We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
NOTE:
When mounting the microwave oven, thread power cord through hole in bottom of top cabinet. Keep it
tight throughout Step 1-3.Do not pinch cord or lift oven by pulling cord.
nylon grommet
metal cabinet
Turn two full turns on each screw.
24
Step-by-step installation guide
power cord
power cord
hole
self-aligning
machine screw
washer
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND
THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
1.Lift microwave ,tilt it forward, and hook slots at back
bottom edge onto four lower tabs of mounting plate.
2.Rotate front of oven up against cabinet bottom.
3.Attach the microwave oven to the top cabinet.
4.Insert 2 self-aligning machine screws(1/4"-20X3") through
outer top cabinet holes.Temporarily secure the oven by
turning the screw at least two full turns after the threads
have engaged. (It will be compeltely tightened later.) Be sure
to keep power cord tight. Be careful not to pinch the
cord,especially when mounting flush to the bottom of
cabinet.
The Filler Block is only used for recessed cabinet and front
overhang cabinet(see the type of the cabinet on page
10、11)，you should place the Filler Block to the cabinet
bottom before installing the oven.
Cabinet Front
Cabinet Botto
Microwave Oven top
5.Tighten the outer two screws to the top of the microwave
oven.(While tightening screws, hold the microwave oven in
place against the wall and the top cabinet.)
6.Install grease filters. See the USER GUIDE packed with the
microwave.
Washer
Filler Block
Equivalent to
Depth of Cabinet
Recess
Self-Aligning machine Screw