Attach Mounting Plate To The Wall; Use Top Cabinet Template For Preparation Of Top Cabinet; B4. Adapting Microwave Blower For Outside Back Exhaust - Hisense HMO173SR Installation Instructions Manual

B 2.

ATTACH MOUNTING PLATE TO THE WALL

Attach the mounting plate to the wall using the wing nuts and machine screws (3/16" x 3").At least one
wood screw must be used to attach the mounting plate to a wall stud.
1.Insert the machine screws(3/16"x 3") into the mounting plate through the holes designed to go into drywall
and attach the toggle wings to ¾" onto each machine screw(3/16"x 3").
2.Place the mounting plate against the wall and insert the toggle wings into the holes in the wall to mount
the plate.
CAUTION: Be careful to avoid pinching fingers between the back of the mounting plate and the wall.
3.Tighten all bolts. Pull the mounting plate away from the wall to help tighten the bolts.
B 3.

USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET

You need to drill holes for
B 4.
ADAPTING MICROWAVE BLOWER FOR OUTSIDE BACK EXHAUST
1.Remove and save screw that holds blower motor to microwave, Lift up the blower plate.
2.Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower
unit.
Step-by-step installation guide
the top support screws
B lower Motor
Back of
Microwave
Blower Plate screw
Blower motor screw
To use toggle bolts
Spacing for Toggles More
Than Wall Thickness
Wing nut
Mountin
Plate
Wall
and a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet bottom.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION : Wear safety goggles when
drilling holes in the cabinet bottom.
BEFORE : Fan Blade
Openings Facing UP
machine
screw
Bolt End
19