Aligning Top Line Of Rear Wall Template - Hisense HMO173SR Installation Instructions Manual

D.

ALIGNING TOP LINE OF REAR WALL TEMPLATE

CAUTION: Wear gloves to avoid cutting fingers on sharp edges.
1. Using tape measure, drawing a vertical line on the wall at the center of the 30" wide space.
2. Tape the rear wall template on the cabinet wall ,align the center markers on the rear wall template to the centerline on wall,
making sure it is level and that the top line of the rear wall template is butted up against the bottom edge of the upper cabinet.
3. According to the shape of cabinet, the location of rear wall template is compliant with the content C. "determining top line
of rear wall template location under your cabinet".
4. While taping the rear wall template on the wall draw circles on the wall at hole A,B,C (See illustration above/actual plate
marked with arrows).THREE HOLES MUST BE USED FOR MOUNTING. (If there are 2-wall studs in right and left side based
on center line Four hole must be used for mounting)
5. Remove the rear wall template and check the marking based on the actual mount plate (centerline, hole A,B,C).
6. Drill holes on the circle marks(A、B、C). Drill a 3/16" hole at C for wood screw and two 5/8" holes at A、B for toggle bolts .
NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.
8. If the rear wall template is damaged or unusable, measure and mark the wall with the dimensions describe in step E.
E. MARK REAR WALL OF THE CABINET WITHOUT REAR WALL TEMPLATE
bottom edge line of upper cabinet
"
15 1/2
(394.5mm)
"
1/3
11
(287.5mm)
Mounting plate end hole(right/leĀ
12
Step-by-step installation guide
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaus
cutout .Do not use this temlate for vertical o
recirculation exhaust
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. Return to and proceed with the installatio
instructions
Locate and mark holes to align with holes in the
mounting plate.
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTER LINE.
MARK THE LOCATION FOR 2 ADDTIONAL,EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Trim the rear wall template along the dotted line
A
2/5
16
(417mm)
"
1/3
11
(287.5mm)
Bottom edge Line of Mounting Plate
3/8" TO EDGE
F.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE
REAR WALL TEMPLATE
3 0 " M I N I M U M W I D T H R E Q U I R E D
Cent r line notches e
C
Area E
1. The Bottom edge line of Mounting Plate must be
16 2/5 " (417mm) from the Bottom edge Line of Upper
"
cabinet and must be level.
2. Mounting plate end holes must be 15 ‰" (394.5mm) from the
Bottom edge Line of Upper cabinet must be on a equal line with
each other.They must each be 11 1/3" (287.5mm) from the center
line.
B