Husqvarna 545FR Operator's Manual page 11

To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING: Use protective gloves.
WARNING: Always use the cutting
attachment guard that is recommended for
the cutting attachment. See
page 30 .
WARNING: An incorrectly attached cutting
attachment can result in injury or death.
To attach the guard extension
CAUTION: Use the guard extension when
you use a trimmer head/plastic blade. Do
not use the guard extension when you use a
grass blade.
1. Put the guard extension in the groove of the cutting
attachment guard.
2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
1018 - 005 - 08.06.2020
To remove the guard extension
•
To attach the grass blade and the grass blade
guard/combination guard
1. Put the blade guard/combination guard (A) onto the
2. Make sure that the guard extension is removed.
Accessories on
3. Turn the output shaft to align one of the holes in the
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support cup (E) and the
Release the locking hooks with the spark plug
wrench.
shaft and tighten the bolt to attach it.
drive disc (B) with the related hole in the gear
housing.
support flange (F) on the output shaft.
D
C
A
A
G
E
F
B
11