M2505 External Sync - Hamamatsu Photonics c2400 Instruction Manual

1 0 . 3 M 2 5 0 4 V I D E O
INVERTER
T h
10.4 M 2 5 0 5 u s e .
EXTERNAL
SYNC
In this position (lower), the output video signal is inverted with regard
t o input intensity as indicated below.
The VIDEO INVERTER option comes completely adjusted and ready for
use.
Installation:
1. T u r n POWER s w i t c h OFF on the Camera Control Unit (CCU).
2. U n p l u g the CCU power supply cord.
3. U s i n g a small Phillips screwdriver, loosen the 4 screws on the side
of the CCU and remove the cover.
4. I n s e r t the M 2 5 0 4 option card i n t o the connector labeled J C I N -
VERTER as illustrated in the figure below.
5. R e p l a c e the CCU cover making sure that the air vent is located on
the left and tighten the 4 holding screws.
e EXTERNAL SYNC option comes completely adjusted and ready for
Installation:
1. T u r n POWER switch OFF on the Camera Control Unit (CCU).
2. U n p l u g the CCU power supply cord.
3. U s i n g a small Phillips screwdriver, loosen the 4 screws on the side
of the CCU and remove the cover.
4. I n s e r t the M2505 option card into the connector labeled JD SYNC
as illustrated in the figure below.
Inversion