U N P A C K I N G; I N S T A L L A T I O N Site - Hamamatsu Photonics c2400 Instruction Manual

C a r e f u
6.1 U n p a c k i n g d e s c r i b e d in Section 3 of this manual are secure and undamaged.
W h e
6.2 Installation Site points:
C o n n e c
6.3 I n s t a l l a t i o n o f v i a a standard, 1" C-mount adaptor.
C a m e r a H e a d D e p e n d i n g on the geometry of the camera head installation it may be
6. INSTALLATION
l l y unpack the equipment, and see that all system components
n installing the equipment, attention should be paid to the following
1. D o not use or locate the equipment near a strong electrostatic or
magnetic field.
2. Situate where temperature is in the range of 0 - 4 0 ° C.
3 T h e site chosen should be relatively free of temperature fluctuations.
4. Humidity should be maintained at less than 90 % (non-condensing).
5. Location site should be free of vibration.
6. T h e instrument should not be exposed to highly corrosive gas(es).
(Chlorine, fluorine, etc).
7. K e e p location clean.
8. A v o i d direct exposure to sunlight.
9. A l l o w adequate space around the CCU for efficient air exchange —
exhaust fan at rear of CCU and side vents.
t i o n of the camera head to the optical imaging system is made
necessary to stabilize the camera via a camera stand, base plate, etc.
7