Advertisement
Assembly
Wind the cable around the aluminum tube arm, keep the elastic moderately tight/loose, so that the cable
won't sway or interfere with operation and clothing. Tighten appropriately the two ends nuts, and adjust the
search coil location to let the search coil be parallel with the ground. Be careful not to mistake the search
coil location.
Battery
Please use 6 Alkaline 'AA' batteries.
Slide the cover labeled "OPEN" on the battery tray cover slot in the direction of the arrow, to pull out
the battery cover. Then insert the 6 x 'AA' batteries into the compartment as indicated by the polarity
symbols marked inside the compartment. Be sure to observe proper polarity when inserting batteries.
Once the batteries are inserted correctly, replace the battery cover.
You will hear a beep tone. Don't mix the new and old batteries.
Control Panel and LCD screen
www.PyleAudio.com
Advertisement
