Pyle PHMD55 Manual page 7

Powering On
Press the POWER ON button, the detector will sound three frequencies of low, medium and high tones, the
liquid crystal dsplay shows the discrimination mode and the sensitivity.
*When the TARGET ID is not illuminated, that indicates the metal detector is in the 'ALL METAL' mode.
*Whichever 'DEPTH-SENS' segment is highlighted, that indicates the metal detector has detected an object
within that depth range. The approximate depth will be displayed
All Metal Mode
When turning on the unit, the detector will be in the 'ALL METAL' Mode. This is the general / typical
metal detector mode that provides indication of any recognizable and compatible metal object found.
Operation
Turn on
Sweep iron nail
Sweep 5¢ or pull-tabs
Sweep 25¢
Indication LCD
tone TARGET ID
Turn on Nothing
indication displayed
The IRON is
low tone illuminated
and flickers
MID RANGE
medium
is illuminated
tone
and flickers
SILVER
high tone illuminated
and flickers
LCD
DEPTH-SENS
SENS-3
is illuminated
DEPTH-2
is illuminated
and flickers
DEPTH-2
is illuminated
and flickers
DEPTH-2
is illuminated
and flickers
www.PyleAudio.com
LCD Chart
If the height of the
metal sample from
the search coil is
changed, the
lighted segment
numbers of the
LCD depth cursor
will be changed
correspondingly.
Note