Advertisement
Troubleshooting
SYMPTOM
No power, there is no indication on
the LCD display, there is no sound
when powering on
Sound heard is an irregular tone, or
the target identification cursor
chatters / distorts
The signal is unstable and the
position of the target identification
cursor is changing
Using PINPOINT mode. when
approaching the ground, the unit
automatically sounds a tone
1.Be sure batteries are installed correctly.
2.Be sure battery cover is closed correctly.
3.Replace the batteries.
Make sure there are no electromagnetic interference sources
present, such as power lines, cables, electronic fences, etc.
Keep away from areas that are prone to cause interference or
you can reduce the detector's sensitivity.
1.Scan at a different angle, in order to determine whether you
can get a more stable signal.
2.If the target is buried deeply, you could try to increase the
sensitivity or speed up the search coil scanning speed,
hovering over the designated area. .
3.Maybe more than one metal targets are buried, you could
try to increase the sensitivity or set different discrimination
ranges when scanning.
4.Maybe you found a severely oxidated target, or the ground
contains some type of magnetic field or mineralized content.
Attempt to decrease the sensitivity and continue scanning.
1.The soil is magnetic, Press the PINPOINT button again,
and reduce the sensitivity -- and scan the area again.
2.There are large metal objects under the ground.
www.PyleAudio.com
SOLUTION
Advertisement
