Advertisement
34
S a s h a DAW I n s ta l l at i o n a n d C a r e
Section 3.2—Leveling the Sasha DAW
1.
Place a level on the left to right oriented axis in the flat area
atop the woofer behind the Upper Module. If it is level, move
to the next step.
2.
You may rotate the spike tips in place by hand..
3.
Lengthen the appropriate spike or spikes (not the Woofer Mod-
ule Spike diode on the set screw) on that lower side until the
Sasha DAW is level.
4.
If the speaker is leaning to the left, lengthen both Woofer Mod-
ule spikes on the right hand side of the speaker. If the speaker
is leaning right, lengthen the left hand spikes. Lengthen the
spikes incrementally, checking and rechecking the level until
the Sasha DAW is level left to right.
5.
Place a level on the front to back oriented axis. If it is level,
then Sasha DAW is level. If the Sasha DAW is leaning one way or
the other, following the same process as above, lengthen the
appropriate spikes on the front or rear of the Woofer Module
until the Sasha DAW is level.
6.
To find out which spike to lower, grasp the Sasha DAW channel
and gently rock it back and for th. This will identify the spike
A u t h e n t i c
G u i d e
E x c e l l e n c e ™
S
3 . 3 — r
P
e c t i o n
e m o v i n g t h e
r o t e c t i v e
that is out of level from the other three. If there is movement,
lengthen the appropriate spike until the Sasha DAW sits solid-
ly on the floor. Make sure the spike is penetrating the carpet
sur face and is resting on the solid floor beneath.
7.
Once all adjustments have been made, with the 3/4" wrench
provided, tighten the nut on the spike to the diode. DO NOT
OVERTIGHTEN! "Snug" is tight enough.
Section 3.3—Removing the Protective Film
To protect the finish of the Sasha DAW during final manufacture, ship-
ment, and setup in your listening room, we have applied a removable layer of
protective film over the finish. We recommend that this film be left in place until
the speakers are in their final location in your listening room. Once you have
determined their final position, remove the film by following this procedure:
1.
Ensure the speaker sur face is room temperature before remov-
ing the protective film. Removing the protective film when the
speaker sur face is cold can damage the paint sur face.
2.
Slowly remove the film from the top down, large sections at a
time, gently pulling the film downward and outward. Tearing
the film aggressively can damage the paint.
3.
Take care in removing the protective film near edges and cor-
W i l s o n
A u d i o
S p e c i a l t i e s
35
F
i l m
Advertisement
