Table of Contents
Advertisement
Emergency Procedures
5. Use the following procedures to remove the safety plug and disable the high voltage battery:
a) Remove the safety plug cover (A) located in
the trunk.
b) Remove the safety plug using the following
procedure :
1: Unlock → 2 : Release → 3 : Remove
WARNING
• Even after the safety plug is removed, please
wait for 5 to 10 minutes in order to discharge
the high-voltage capacitor located in the
inverter.
If either method of disabling system is not completed, the vehicle will be prone to accidental
deployment of airbags and electric shock from high-voltage components.
WARNING
• Before engaging in emergency response procedures, ensure the vehicle is disabled and wait for
more than 5 minutes to allow the capacitor in the high voltage system to discharge to avoid
electrocution.
• Exposed cables or wires may be visible inside or outside the vehicle. To prevent injury or death
due to electrical shock, never touch the wires or cables before disabling the system, to prevent
injury or death due to electrical shock.
Failure to follow any of these instructions may result in serious injury or death by electrocution.
WARNING
• Do not cut through any component.
• SRS components may remain powered and active for up to 3 minutes after the 12V electrical
system is shut off or disabled. Disconnect the battery negative cable and wait for at least 3
minutes before beginning work.
Failure to follow any of these instructions may result in serious injury or death from accidental
deployment of the airbag system.
Electrocution Risk!
Explosive Risk!
22
Advertisement
Table of Contents
