Hyundai NEXO Emergency Response Manual page 22

Emergency Procedures
Disable
The next step in the initial response process, conducted after the vehicle is secured to prevent
movement, is to disable the vehicle, its SRS components and the high voltage electrical system. To
prevent current flow through the system, use one of the following procedures to disable the
vehicle.
Ⅰ. Disabling the system – Smart Key System and "POWER" START/STOP BUTTON
1. Check the status of the READY light on
the instrument panel. If the READY light is
illuminated, the vehicle is on.
(Refer to page 8)
a)If the READY light is NOT illuminated, the
vehicle is off, Do not push the "POWER"
START/STOP button because the vehicle may
start.
b) To turn off the system, put the shift lever in the P (Park) position and press the POWER button
beside the shift lever.
Without depressing the brake pedal
Pressing
POWER button
One time
Two times
Three times
Depressing the brake pedal while a shift lever is in the P (Park) position
Pressing
POWER button
One time
NOTICE
• To turn off the vehicle in an emergency while driving, hold the start button for over 2 seconds or
press the button three times within 3 seconds. The vehicle will turn off and switch to 「ACC」 status.
While driving, it is possible to turn on the vehicle again by placing the shift gear in N (Neural)
without depressing the brake. Never turn off the vehicle during normal driving.
Button Position
OFF
ACC
ON The warning lights can be checked before the vehicle is started.
OFF
Button Position
OFF
-
"POWER" START/STOP Button
Vehicle condition
Off
Electrical accessories are operational.
Off
Vehicle condition
Off
Ready to drive
19