Advertisement
6. Deleting all transmitters
Proceeding with this instruction will cause for all transmitters to be deleted form receivers memory.
power on.
7. Activating impulse mode
When impulse mode is activated, single push of UP or DOWN button forces motor to make single part of a full turn, and
when UP or DOWN button is being held for 2 seconds it will force motor to run constantly.
power on.
Switch
Simultaneously press and hold
STOP and DOWN button
for about 6 seconds.
Switch
Simultaneously press and hold
UP and STOP button
for about 6 seconds
The LED on the receiver will
flash and then turn off.
Impulse mode has been activated.
Repeat these steps to deactivate
The LED diode on the receiver
will flash and then turn off.
3
Programmed
transmitters were
successfully deleted.
the impulse mode.
Advertisement
