Subaru IMPREZA 2002 Service Manual page 46

PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
I
40.AT SHIFT CONTROL
Set the AT selector lever to each gear position
while checking that the demanded gear position is
correctly attained.
Selector lever gate pattern
Selector Gear Position
Position
Yes Yes Yes
Yes Yes Yes
I
2
I
Yes
I
Yes
I
1
I
Yes
I
Check the shift lock system operations.
Check the key interlock system operations.
41 .HEATER & VENTILATION
Operate the heater and ventilation system to check
for normal airflow and heating capacity.
42.AIR CONDITIONER
Operate the air conditioner. Check that the A/C
compressor operates normally and enough cooling
is provided.
43.CRUISE CONTROL
Operate the cruise control system. Check that the
system is activated and deactivated correctly.
44.ATF LEVEL
Check that the ATF level is normal. If insufficient,
check that no leaks are found. Then add the neces-
sary amount of the specified ATF.
Lower level
<-upper
level
1-
Lower level
G10098A
45.POWER STEERING FLUID LEVEL
Check that the power steering fluid level is normal.
If insufficient, check that no leaks are found. Then
add the necessary amount of the specified power
steering fluid.
46.FLUID LEAK CHECK
Check the entire areas of the vehicle for any trace
of coolant/oil/fluid leaks.
47.WATER LEAK TEST
Spray the vehicle with water and check that no wa-
ter enters the passenger compartment.
Before performing the water leakage test, re-
move anything that may obstruct the operation or
which must be kept dry.
Close all of the windows completely, and then
close all of the doors tightly. Close the hood and
trunk lid before starting the test.
Connect a hose to a tap, and spray water on the
vehicle. The rate of water discharge must be ap-
prox. 20 to 25 liters (5.3 to 6.6 US gal, 4.4 to 5.5
Imp gal) per minute.
When spraying water on areas adjacent to the floor
and wheel house, increase the pressure. When di-
recting water on areas other than the floor portion
and wheel house, decrease the pressure. But the
force of water must be made strong occasionally by
pressing the end of the hose.
NOTE:
Be sure to keep the hose at least 10 cm (3.9 in)
from the vehicle.
Check the following areas:
Front window and body framework mating
portion
Door mating portions
Glass mating portions
Rear quarter window mating portions
Rear window and body framework mating
portion
Around roof drips
PI-I 2