Security System - Subaru IMPREZA 2002 Service Manual

PRE-DELIVERY INSPECTION
PRE-DELIVERY INSPECTION
I
23.SECURITY SYSTEM
Check the security system operations as follows:
Fully open all the door windows.
Remove the key from the ignition switch and
close all the doors including rear gate (wagon).
Press the "LOCWARM" button on the transmitter
momentarily once and check if all the doors are
locked, the horn chirps once, the parking lights
flash once and the security indicator light flashes
slowly to ensure that the security system has been
brought into the arming state.
c-
GI0091
Press the "UNLOCWDISARM" button on the
transmitter momentarily once and check if the driv-
er's door is unlocked, the horn chirps twice, the
parking light flash twice, the dome light illuminates
and the security indicator light goes off to ensure
that the system has been brougt into the disarming
state.
I I
GI0092
Press the "UNLOCWDISARM" button on the
transmitter momentarily once again within five sec-
onds and check if all the doors including the rear
gate on wagon are unlocked.
Press the "LOCWARM" button on the transmitter
a little bit of time (approx. 1.5 sec.) and check if a
panicking condition occurs; the horn sounds contin-
uously, the parking lights flash and the security in-
dicator light flashes rapidly. Also, check if that
condition lasts for 30 seconds or until any button of
the transmitter is pressed.
Press the "LOCWARM" button on the transmitter
momentarily once with one of the doors including
the rear gate (wagon) open and check if the horn
chirps three times to warn of a door ajar.
Then, bring all the doors including the rear gate
(wagon) in closed condition and check if the arming
condition is brought about; all the doors are locked,
the horn chirps once and the parking lights flash
once.
Press the "LOCK' side of the power door locking
switch with any one of the doors including the rear
gate (wagon) open. Then, bring all the doors in-
cluding the rear gate (wagon) in the closed condi-
tion and check if all the doors are locked, the horn
chirps once and the parking lights flash once to en-
sure that the security system has been brought into
the arming state.
LOCK
Unlock a door using the inner lock knob or the
key and open the door while the security system is
in the arming state. Check to ensure that the alarm-
ing condition occurs, i.e. the horn sounds continu-
ously, the parking lights flash and security indicator
light flashes rapidly, and that it lasts for 30 seconds
or until the "UNLOCWDISARM" button on the
transmitter is pressed. Also, check to ensure that
turning the ignition key to the "START position in
the arming state does not cause the starter motor
to turn, thus the engine being prevented from start-
ing.
Apply a shock to the vehicle body with the secu-
rity system in arming state, and check to ensure
that the alarming condition occurs.
Troubleshoot the security system if any one of
the above-mentioned checks does not meet the re-
qui remen ts.
24.SEAT
Check that each seat provides full functionality in
sliding and reclining. Check all available functions
of the rear seat such as a trunk-through center arm
rest.
25.SEAT BELT
Pull out the seat belt and then release it. Check
that the belt webbing retracts smoothly.
Check the seatbelt warning light and chime oper-
ations.
PI-I 0