Subaru IMPREZA 2002 Service Manual page 45

PRE-DELIVERY INSPECTION
1
PRE-DELIVERY INSPECTION
Nozzle
(/
I \
I \
I \
1 ? K
26.WHEEL ALIGNMENT
Check the wheel alignments. <Ref. to FS-8, Wheel
Alignment.> and <Ref. to RS-9, Wheel Alignment,
.>
27.READ MEMORY AND TEST MODE CON-
NECTORS
Turn the ignition switch to ON and check that the
check-engine light starts blinking. If the light blinks,
return the ignition key to LOCK and disconnect the
test mode connector. Then, turn the ignition key to
ON again. If the check-engine light blinks at that
time in spite of the disconnected test mode connec-
tor, carry out an engine diagnosis.
___
28.KEY WARNING SYSTEM
Check that the chime sounds when the driver's
door opens and the key is in the "LOCK' or "ACC"
position.
29. STA RTI N G CON DIT1 0 N
Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any ab-
normal noises are observed, immediately stop the
engine and check and repair the necessary compo-
nents.
30.EXHAUST SYSTEM
Listen to the exhaust noise to see if no abnormal
noises are observed.
31 .INDICATOR LIGHT
Check that all the indicator lights are off.
32.CLOCK
Check the clock for normal operations and enough
accuracy.
33.RADIO
Check the radio for full functionality and normal
noise level. Also check the CD unit operations.
34.CIGARETTE LIGHTER
Check the cigarette lighter operations.
35. LIGHTING SYSTEM
Check the headlight operations.
Check the brake light operations.
Check the other lights for normal operations.
Check the daytime running light system opera-
tions.
Check the illumination brightness control system
operations.
36.WINDOW WASHER
Check that the window washer system injects
washer fluid to the specified area of the windshield
shown in the figure.
Front Injection position:
A: 257" (IO. 12 in)
B: 512" (20.16 in)
Rear Injection position:
A: 39 mm (2.36 in)
B: 72"
PI-I 1