Honeywell homexpert Rondostat COMFORT+ HR30 Manual page 3

Selecting the adapter
The radiator controller fits on the most common radiator
valves M30 x 1.5. Adapters are required for some valve
types.
1. Check whether an adapter is required and, if
necessary, select the appropriate adapter.
Make
Valves M30 x
1.5 Honeywell-
Braukmann,
MNG, Heimeier,
Oventrop
Danfoss RA
Danfoss RAV
Danfoss RAVL
2. Slide the adapter onto the radiator valve and turn it
until you feel it click into place.
3. If necessary, screw the adapter tight with a screw.
Mounting the valve baseplate
1b
1. Separate the valve baseplate from the radiator
controller. To do so, slide the slide towards the
Illustration adapter
required
Supplied
Supplied
Supplied
1a
2. Turn the adjustment dial of the valve baseplate anti-
Not
clockwise until it stops.
3. Put the valve baseplate onto the radiator valve or the
adapter and tighten by hand (without tools!).
Mounting the radiator controller
3.
1. Ensure that the slide at the radiator controller is in the
open position.
2. Push the radiator controller onto the valve baseplate
so that the geer teeth catch and are no longer visible.
3. Lock the radiator controller in the end position. To do
so, slide the slide towards the
The radiator controller carries out a self test and after
1 minute displays
controller changes to automatic mode.
i
The radiator controller only functions if it is
interlocked in the end position.
FINISHED! – Your radiator controller is now ready for
operation with the factory setting!
Securing controller and battery compartment
i
The radiator controller and battery compartment
can be secured against being removed or opened by
means of a screw. These screws are not included in
the packaging.
.
- 3 -
3.
2.
1.
2.
.
. Subsequently the radiator
cycl
Countersunk screws
Torx/corss recess 2.2x8mm
Type: WIN1412-KC22X8-Z or
WIN1412-KB22X8-Z