Table of Contents
Advertisement
Problem
Incomplete Fusing
Toner appears to be pulled off print, or is easy
to rub off.
Color Misregistration
Color has shifted outside of the designated
area or has been superimposed over another
color area.
See
www.xerox.com/officeprinting/infoSMART
Page 3 of 3
Solution
1.
Open the top cover and make sure the orange fuser
restraint pin is removed and the green lever on the back
side of the Fuser is in the locked positon.
2.
Turn the printer off and then on.
3.
From the printer's front panel
Print
Quality?, then select
OK.
4.
Ensure the paper you are using is the correct type for the
printer and is properly loaded.
5.
Ensure the paper loaded in the tray matches the paper
type selected on the printer's front panel and in the
computer's printer driver.
6.
If the problem persists: .
a.
From the printer's front panel
Tray Setup Menu
printing from (i.e., MPT, Tray 1, etc).
b.
Select
Set Paper Type
c.
Use the Back button to return to the
and select
Special Paper Setup
d.
Scroll to a heavier paper type and press OK.
1.
Turn the printer off and open the top cover.
a.
Visually inspect the four LED bars for any foreign
material.
a
b.
Visually inspect the Imaging Units and remove any
foreign material if found.
2.
Close the top cover.
3.
Turn the printer on. The printer will
perform an automatic registration alignment.
Caution:
Do not leave the top cover open for more than
10 minutes without covering the Imaging Unit as damage
could result. Use the dark bag that came with the Imaging
Unit or dark paper as a cover.
on the world wide web for more on-line support information.
Support Menu
select
Print Paper Tips Page
Printer Setup Menu
and press OK. Select the tray you are
and then select Special.
Tray Setup Menu
Menu.
Improve
and press
select
Hide quick links:
Advertisement
Table of Contents
