Advertisement
②
Correct pairing will be confirmed by temporary switching off of the output
③
circuit and the LED will turn on again.
The receiver can be paired with eight different transmitters (remote but-
tons). Pairing with more buttons will remove the first entries made.
Unpairing
To clear the list of transmitters cooperating with the receiver, press the PROG button and hold it
down for at least 10 seconds. Fast flashing of communication LED will indicate that the memory
of the controller has been cleared.
Local buttons
Short press of a button switches on/off the lighting on the last set brightness level. Long press of
a button (longer than 1 second) increases the brightness level (in a jump of 10%). Another long
press of a button decreases the brightness level.
Remote buttons
The FW-RC4, FW-RC10 transmitters operate on the principle of a bistable switch: one
press of a button activates the relay; the second press of button deactivates the relay.
Long press of a button (longer than 1 second) increases the brightness level (in a jump
of 10%). Another long press of a button decreases the brightness level.
The FW-RC5 transmitter also has separate inputs ON (always ON) and OFF (always
OFF).
Due to the nature of transmission and retransmission do not use the same but-
ton in transmitter more often than every 2 seconds. Switching of the receiver
may be carried out with a short delay.
Press the selected button on a remote control or in
a flush-mounted transmitter.
- 4 -
Advertisement
