Table of Contents
Advertisement
A A A A
Open the bypass tray.
B B B B
Adjust the paper guides to the paper size.
Important
❒ If the paper guides are not flush against the paper, skewed images or paper
misfeeds might occur.
C C C C
Gently insert the paper face up in the bypass tray until the beeper sounds.
2
1.
Extender
2.
Paper guides
Note
❒ Be sure to set paper in L orientation as shown in the illustration above.
❒ The beeper will not sound if it is turned off. Gently insert the paper until it
stops.
❒ Do not stack paper over the limit mark, otherwise a skewed image or paper
misfeeds might occur.
❒ Open out the extender to support paper sizes larger than A4 L , 8
❒ Fan the paper to get air between the sheets to avoid a multi-sheet feed.
❒ When setting an OHP transparency, make sure that its front and back sides
are properly positioned.
❒ Select the paper type when printing on OHP transparencies or thick paper
(over 105g/m
encies".
ZGUH030E
1
ZGWH071E
2
). For details, see p.18 "Setting thick paper or OHP transpar-
Setting Paper on the Bypass Tray
"×11" L .
1
/
2
1
15
Advertisement
Table of Contents
