Firmware Upgrade Instructions; Upgrading The Cloudmesh Satellite's Firmware - NetComm CloudMesh NS-01 Firmware Upgrade Manual

Satellite access point

Hide thumbs Also See for CloudMesh NS-01:

NS-01 Firmware upgrade instructions

Using the same computer that you had set the static IP address on in the previous section:

Connect the supplied power adapter into the USB connection on the bottom of your CloudMesh Satellite (NS-01) and

plug the power adaptor into a power point.

If necessary, switch the power point switch on at the wall.

Allow 60 – 90 seconds for the NS-01 to power up.

Connect the supplied RJ45 Ethernet cable from one of the two yellow ETHERNET ports on the bottom of the NS-01

CloudMesh Satellite to an Ethernet port on your computer.

Open a web browser (e.g. Internet Explorer, Firefox, Safari, etc) and type in the static IP address that you had set in

the previous section, for example 196.168.1.1, into the address bar and press the Enter button.

At the Authorization Required screen:

Type admin into the Username field,

Enter the serial number (Serial No) printed on the label on the label on the bottom of the NS-01 into the

Password field, and

Click the Login button.

Select System > Backup/Flash Firmware from the menu in the toolbar of the screen:

Firmware Upgrade Guide

FW01226 v1.0 24 March 2020

Figure 7 – Log in to NS-01 user interface

Figure 8 – Check current firmware version

9 of 11

Table of Contents

Show Quick Links