Download Print this page

HURST RABBIT TOOL Instructions

Download this manual

HURST

RABBIT

The RABBIT TOOL comes pretested, and

ready to use. It is recommended, however,

that the system be cycled a few times to test

the system for proper operation.

NOTE: The RABBIT TOOL is not an auto extrication tool.

Instructions

Package consists of:

1 Rabbit Tool

1 6 ft. hose

1 Manual pump

1 Pry bar

1 Hammer

1 Carrying bag with dual

purpose detachable sling

(Sling may be used to carry tool without bag)

Record the serial number (stamped on tool)

onto the warranty card and mail the postage

paid registration to Hale Products, Inc. to

begin warranty.

Patent No. 4,443,001

Page 1 1 Carrying bag with dual purpose detachable sling (Sling may be used to carry tool without bag) NOTE: The RABBIT TOOL is not an auto extrication tool. Patent No. 4,443,001 The RABBIT TOOL comes pretested, and Record the serial number (stamped on tool) ready to use.
Page 2 The user must be familiar with the correct operation, that the fluid flow within the hose is blocked or reduced. maintenance, and use of the RABBIT TOOL. Lack of Periodically inspect the hose for wear because any of knowledge in any of these areas may lead to personal these conditions can damage the hose and possibly result injury.
Page 3 Rotate the coupling sleeve 1/4 to 1/2 turn to lock the con- INSTRUCTIONS nection. To use the RABBIT TOOL, insert jaws of tool between door and jamb, as shown. If there is not enough space for jaws (1/4 in.) create a larger opening with pry bar or strike jaw anvil with hammer provided.
Page 4 3. Restricted hydraulic line C. Clean or replace if Pump handle oper- 1. Air has been trapped in A. Set Rabbit Tool lower or fitting damaged. ates with a spongy the line than the pump and extend...