Balluff BTL7-S5 M Series Condensed Manual page 4

BTL7-S5 _ _ ( _ )-M _ _ _ _ -A/B/Y/Z(8)-S140
Transducer — Rod Style
The CE Mark verifies that our products
meet the requirements of the current
EMC Directive.
Intended use
The Transducer, together with a machine controller (e.g.
PLC), comprises a position measuring system. It is
intended to be installed into a machine or system and
used in the industrial sector. Flawless function in
accordance with the specifications in the technical data is
ensured only when using original Balluff accessories. Use
of any other components will void the warranty.
Opening the transducer or non-approved use are not
permitted and will result in the loss of warranty and liability
claims against the manufacturer.
General safety notes
Installation and startup may only be performed by
trained specialists.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the position
measuring system will not result in hazards to persons or
equipment.
If defects and unresolvable faults occur in the transducer, it
should be taken out of service and secured against
unauthorized use.
Downloading further instructions
A complete user's guide can be downloaded from the
Internet at www.balluff.com or requested via e-mail from
service@balluff.de.
BTL7...-S140
12.8
2) Unusable area
3) Not included in scope of delivery
Version D1
...-A/B/Y/Z-... 10.2 mm
...-A8/B8/Y8/Z8-... 8 mm
1 english
Mounting surface
B: 30-1 mm
Z: 2"-0.04"
2)
Magnet
Thread size
0.5 Ø 25
B: M18×1.5
Z: 3/4"-16UNF
74.5 25
G
Thread M4x4/
6 deep
No thread
Dimensions and function
The BTL7 transducer contains the waveguide which is
protected by an outer stainless steel tube (rod). A magnet
is moved along the waveguide. This magnet is connected
to the system part whose position is to be determined.
In normal operation, the LEDs indicate the operating states
of the transducer:
LED 1
Normal function
Green
Magnet is within the limits.
Red Error
No magnet or magnet outside the limits.
LED 2
Green Synchronous operation 1)
Internal measurement is synchronous to SSI
query.
Off Asynchronous operation 1)
Internal measurement is asynchronous to SSI
query.
Flashing Programming mode
green Only with BTL7-S510...
1) Asynchronous operation is reached when the external sampling rate is
> f or < 62.5 Hz (only with BTL7-S5_ _B/F-...).
A,max
Damping zone
60
Nominal length =
Measuring range
3)
A: 30-1 mm
Mounting surface
A-SA211: 2"-0.04"
Y: 2"-0.04"
2)
74.5 25
File no.
E227256
2)
LED 1
LED 2
45
46
3)
Thread size
A: M18x1.5
Y: 3/4"-16UNF