Dtmf - Radioddity GA-510 Programming Manual

3) DTMF

Name Setting
DTMF ST OFF: No DTMF Side Tones are heard
(DTMF side tone of
KB Side Tone: Side Tones are heard
transmit code)
only from manually keyed DTMF codes
ANI Side Tone: Side Tones are heard
only from automatically keyed DTMF
codes
KB ST+ANI ST: All DTMF Side Tones are
heard
Save mode OFF/Mode 1/Mode 2/Mode 3
Scan mode TO: Time Operation - scanning will
resume after a fixed time has passed
CO:
Resume Method scanning will resume
after the signal disappears
SE: Search Operation scanning will not
resume
PTT_ID OFF: No ID is sent
BOT: The selected S-CODE is sent at the
beginning
EOT: The selected S-CODE is sent at the
ending
BOTH: The selected SCODE is sent at
the beginning and ending
PTT Delay 0-30ms
KB_LOCK
AutoLock (automatic
keypad lock)
BCL(busy channel
Lock-out)
Carrier Operation -Scanning
Description
Determines when DTMF side tones can be heard
from the transceiver speaker
Selects the ratio of sleep cycles to awake cycles
(Mode 1/Mode 2/Mode 3). The higher number
the longer the battery lasts. When enabled, a
word or two might be missed when the
frequency being monitored becomes active.
Scanning Resume Method
When to Send PTT-ID; Codes are sent during
either the beginning or end of a transmission.
Signal code sending delay
If you select this option, the keyboard is locked.
When ON, the keypad will be locked if not used
in 8 seconds. Pressing the [# ╓ O] key for 2
seconds will unlock the keypad.
Check: If the channel is occupied, when you
press the [PTT] key on this channel, the radio will
make a beep tone and will not transmit any
signal.
Uncheck: No matter if the channel is occupied,
the radio will transmit the signal when you press
the [PTT] key.
8