Advertisement
Assembly Manual
•
The TWM II wall mount is rated for the assembly of speaker systems weighing up to 11 kg.
•
It is recommended to use an additional securing element to secure each suspended
speaker against falling.
•
In general, a visual inspection of the speaker and accessories is to be performed prior to each
use/assembly. If there are signs of wear, cracking or deformation, they are to be replaced with-
out delay. The visual inspection also includes checking the screw connections on load-bearing
parts of the speaker and accessory.
4. Assembly and use instructions
4.1. Overview of assemblies
Description
TWM swivel bracket (small angle)
Set screw, M6 x 8 mm ring washer, A2, DIN 916
TWM fastening bracket (wall side)
Cylinder screw M6 x 10 mm, A2, DIN 7984
Washer, M6, A2, DIN 9021
A
4.2. Assembly
Improperly selected fastening material for wall or ceiling assembly may cause the speaker to fall
down.
Prior to assembly, it is necessary to check the wall or ceiling material to which the speaker is to be
fastened. Be sure to provide suitable fastening material (dowels and matching screws) for assembly.
Insert swivel bracket (A) into
the rear slot of the speaker
through the opening in the
top cover.
© Pan Acoustics GmbH
B
C
Fasten swivel bracket (A) with
2 set screws (B) in the rear
slot.
Drawing
D
V 1.0
Speaker Mount TWM II
A
B
C
D
E
E
Insert swivel bracket (A) into
the rear slot of the speaker
through the opening in the
bottom cover.
Page 4 of 6
Advertisement
