Attach The Worktable; Attach The Splash Trays - Delta 96-107 Instruction Manual

ASSEMBLY
Attach Worktable
1. Check to make sure the slotted table lock is loosened in
the open position, as shown in Figure 8, so that the groove
A
is parallel to the direction of movement for the table.
B
2. Position the Worktable (4) so that the left bearings
align as shown in Figure 8. The Larger Rollers (B)
C
should be guided on the top of the rails, as the Smaller
Rollers (C) should be guided beneath the rails.
Figure 8
3. Loosen the bolt for the Table Stop (C) with the 4
mm Allen Wrench (5c). To prevent the removal of
the table, rotate the table stop 90 degrees as shown
Figure 9b and tighten. To remove the table, the bolt
will have to be loosened and the table stop rotated
back 90 degrees to position shown in Figure 9a.
D
4. To lock table in place, engage Table Lock (D)
into the rail at location shown in Figure 9a.
Figure 9b
Figure 9a
Attach Guided Tray
1. Attach the Guided Tray (19) to Splash Tray
16
(16) by using three M4 x 10 Phillips Plastic Self
Tapping Screws (H3) as shown in Figure 10.
H3
19
Figure 10
Attach Splash Tray
1. Slide the Worktable (4) forward, as shown in
A
Figure 11a, to attach the Splash Tray (16).
B
2. Align the Pegs (A) into the holes on the Worktable
(4), as shown in Figure 11a. Fasten the two tables
together by tightening the Thumbscrew (B) under
the Splash Tray, as shown in Figure 11b.
A
Figure 11a Figure 11b
10