Summary - Verilink PRISM 4051 Manual

36 C 4: T
HAPTER ERMINAL
O
PERATION

Summary

The Summary screen (Figure 4-15) is a display-only screen that summarizes all
the configuration settings in multiple columns. The left column, labeled Current,
shows the settings the unit is running. The middle column, labeled Saved, shows
what settings have been saved into non-volatile memory. The third column, labeled
Switches, shows the settings of DIP switches S1 through S4.
Configuration Item LL/RL Detect reads DIS/DIS, ENA/DIS, DIS/ENA, or
ENA/ENA in the Current and Saved columns depending on how those parameters
were set through a terminal (see DTE Port Parameters on page 32), but only as
DISABLE or ENABLE in the Switches column because both loopback parameters
are controlled by one DIP switch (S1-7, see Local and Remote Loopback Enable
on page 7).
4051 DDS 255.255/1.02
-------------------------------------- SUMMARY ---------------------------------
Configuration Item
DTE Bit Rate:
Line Bit Rate:
Line Clk Source:
Loop Mode:
RTS Delay Norm/Dbl:
RTS/CTS Norm/On:
Data Mode:
LL/RL Detect:
DTR Alarm:
Antistreaming Timer:
V.54 Loop:
Circuit Assurance:
Supv Bit Rate:
NMS Bit Rate:
Unit ID:
Boot Mode:
------------------------------------ Messages ----------------------------------
Figure 4- 15 Summary Screen
P R I S M 4 0 5 1
(Unit Address: 1)
Current Saved Switches
64K 64K
73K 72K
NET NET
BIDIR BIDIR
NORMAL NORMAL
FORCED FORCED
DDS II DDS II
DIS/ENA DISABLE
ENABLE ENABLE
30 30
DISABLE DISABLE
ON ON
19.2K 19.2K
19.2K 19.2K
252 252
SWITCHES SAVED
Date: 08/23/96
Time: 09:45:36
Other Information
Serial Num: 065535
Port Type: RS232D