Table of Contents
Advertisement
34
C
4: T
HAPTER
ERMINAL
O
PERATION
acceptable performance levels. To modify the parameters, highlight the desired
statistic, type in the new value (any number from 0 to 900) and press Enter. If this
value is later surpassed, an alarm indication appears. A field set to (0) causes the
element not to alarm on that statistic.
Loss of Signal Seconds.
interrupted. Options are 1, 2, 3, 4, 5, 10, 20, 30, and (- -) (none).
Out of Service Seconds.
code is received. Options are 1, 2, 3, 4, 5, 10, 20, 30, and (- -) (none).
Out of Frame Seconds.
received or a frame sync loss occurred. Options are 1, 2, 3, 4, 5, 10, 20, 30,
and (- -) none.
Determines the number of seconds after alarm conditions clear
Alarm Reset Timer.
before indications are removed. Options are 10, 30, 60, 90, 100, 200, 300, 400,
500, 600, 700, 800, 900, and (- - -) (none).
Management Parameters
The Management Ports screen (Figure 4-14) sets the following parameters for the
Call On Alarm (COA) connection on the supervisory (SUPV) port.
COA Connection (SUPV).
ASCII alarm report type is set by the following choices:
DISABLED: Alarm reporting is disabled.
4051 DDS 255.255/1.02
--------------------------------- Management Ports -----------------------------
--------------------------------- Supervisory Port -----------------------------
Loss of Signal Seconds
Primary Dial String:
Secondary Dial String:
Initialization String:
Disconnection String:
------------------------------------ Messages ----------------------------------
Figure 4- 14
Management Ports Screen
A one-second period in which the DDS received signal is
A one-second period during which the Out Of Service
A one-second period in which the Out Of Frame code is
This field controls the remote alarm reporting. The
P R I S M
4 0 5 1
(Unit Address: 1)
[DISABLED]
(
(
(ATE1QV1s0=1
(ATH
Date: 08/23/96
Time: 09:44:36
)
)
)
)
Advertisement
Table of Contents
