Polygroup TGC0P4740L00 Assembly Instructions

TREE ASSEMBLY INSTRUCTIONS
Congratulations on purchasing your new tree from
Quick Fold TM and Simple Shape technology to make set up and storage quick and easy. Carefully follow the
instructions below on how to quickly and easily set up your new tree.
1. Before you start to assemble your tree, choose an appropriate location near a wall outlet.
2. Assemble the tree stand and place on a level surface. (See Fig. A)
Fig. A -
Tree Stand Assembly
Eye Bolt
Fig. B - Tree and Light Assembly
1
3. Each tree section is numbered with a tag. Please identify all sections before assembling.
4. Assemble the tree from bottom to tree top. Start with the bottom section and remove the protective cap
before inserting into the assembled stand. Make sure the pole is firmly inserted and secured into the stand.
SET UP
5.
• Remove tree stand and tree sections from box.
• Insert tree bottom section
• A. Locate "Pull Here" tab and corresponding Cinch Handle
B. Hold Cinch Clip firmly with one hand and press down on clip
C. With Cinch Clip depressed, pull clip away from tree until all
branches are released
D. Locate all clips on the same tree section then repeat above
procedures to release the corresponding branches.
• Remove the protective cap from tree bottom section
insert tree middle section 1
• Release all branches using the same procedures described in step 3.
• Add tree middle section 2
section 4 ,tree middle section 5
5
same procedures described in steps 4 and 5.
6. Allow branches to fall into place or gently pull up and out. When
adjusting branches, be sure that all wires are free of branch hinges.
MODEL #: TGC0P4740L00
Polygroup®!
Eye Bolt
Click
7
6
5
4
3
2
8
into the tree stand .
1 8
1
.
2
, tree middle section 3 , tree middle
4
3
and tree top using the
6 7
This tree features Quick Set® and
1. Pull apart the legs of the stand so that
they are snapped into an x-shape, place the
tree stand on a level surface.
2. When inserting the bottom section of the tree
into the assembled stand, insert and turn the
eyebolts into the stand and tighten until the
tree pole is firmly secured.
To close the stand, remove the eyebolts, press
the metal button and fold the legs together.
*Electrical Rating For The Tree
(For Indoor Use Only)
Input:120VAC, 60Hz, 0.38A
Output: 29V DC 0.9A
Do Not Tamper
Internal Parts
Open the
protective
cover
Do Not Tamper
Internal Parts
Open the
protective
cover
Foot Pedal
on/off Switch
Cinch Clip
B
and
C
Cinch
PULL HERE
Handle
Do Not Tamper
Internal Parts
Open the
protective
cover
Adaptor
To Be Plugged
Into Wall
Outlet
A