Rigid Industries E Series Installation Instructions page 2

step 2
Repeat Step 1 for remaining side.
step 3
Install Rigid Industries light using hardware provided with the light. See Figure 3.
Wiring: Wire your lights according to the instructions included with the light. Take care to
avoid any heat sources and sharp or abrasive surfaces.
Figure 3
For warranty information, visit www.rigidindustries.com/about/warranty
E-Series and Rigid Industries are registered and/or common law marks owned by
JST Performance, LLC, a Delaware limited liability company d/b/a Rigid Industries.
Your installation is now complete.
Welcome to the Rigid Nation!
WARRANTY INFORMATION
Follow us on facebook at
Facebook.com/RigidIndustries
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337 • www.rigidindustries.com
PKG-IS-205-A