Page 1
IOT Gateway Installation Guide and Service Instructions for Smart IOT Gateway Manufacturer reserves the right to change at any time for specifications or designs without notice and incurring obligations. 02.2018...
Page 2
IOT Gateway ■ Installation Guide 1. Be sure to turn off power supply for outdoor unit prior to install the IOT gateway. 2. Securely fasten the waterproof joint of the gateway to the reserved hole. 3. Plug the blue connector into CN11 (IOT) terminal on main control board of outdoor unit.
Page 3
IOT Gateway 4. To keep the best LTE signal, choose one side that is further away from the wall to hang up the IOT gateway. Using screw and belt to tighten the gateway and secure the cable. 5. Power on the outdoor unit and check if the gateway is working properly.
Page 4
IOT Gateway Check by LEDs display The normal working state of gateway should be No.1 LED is blinking with other LEDs are off. Check the display of No.1 LED after power on for 15sec. Always OFF Always ON The gateway is powered off. The gateway boots failed.
Page 5
The continuous offline time of gateway is more than 4 hours. Local link is disconnected. ※ Note: The gateway error code is displayed on the Ecoer Smart Service App. G1/G2: The continuous offline time of gateway is too long. 1.Error definition G1: The continuous offline time of gateway is more than 15 minutes.