Sony SRF-18 Service Manual

SERVICE MANUAL
Ver. 1.1 2012.03
SPECIFICATIONS
Frequency range:
FM: 87.5 MHz - 108 MHz
AM: 530 kHz - 1,710 kHz
Speaker:
7
Approx. 3.6 cm (1 / inches) dia, 7.2
16
Input:
AUDIO IN jack ( 3.5 mm stereo minijack) (1)
Outputs:
(headphones) jack ( 3.5 mm stereo minijack) (1)
AUDIO OUT jack ( 3.5 mm stereo minijack) (1)
Power output:
80 mW + 80 mW (JEITA*)
Power requirements:
3 V DC, two size AA (R6) batteries
Dimensions:
Approx. 155 mm × 78.5 mm × 32.5 mm (6
(w/h/d, projecting parts not included)
Approx. 155.4 mm × 80.3 mm × 34.2 mm (6
(w/h/d, projecting parts included)
(JEITA*)
Mass:
Approx. 198 g (7 oz) (batteries included)
* JEITA (Japan Electronics and Information Technology Industries Association) standards.
Supplied accessories
Operating Instructions (1)
Audio connecting cable (stereo mini plug
Design and specifications are subject to change without notice.
On Copyrights
"WALKMAN" and "WALKMAN" logo are registered trademarks of Sony
Corporation.
9-893-410-02
Sony Corporation
2012C33-1
© 2012.03 Published by Sony Techno Create Corporation
(2)
1 / inches × 3 1 / inches × 1 5 / inches)
8 8 16
1 1 3
/ inches × 3 / inches × 1 / inches)
8 4 8
stereo mini plug) (1)
SRF-18
NOTES ON CHIP COMPONENT REPLACEMENT
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to fl ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
FM STEREO/AM RADIO
E Model