Seal Replacement; Seal Installation - Woods RD60 Operator's Manual

1. 3/8 NF x 1 HHCS GR5
2. Cup washer
3. Sheave
4. Spacer
5. Spindle bearing
6. 3/8 NC Flange lock nut
7. 1/4 Tapered grease fit-
ting
8. Spindle housing
Figure 13. Blade Spindle Assembly
Assemble Spindle
1. Slide lower bearing (5) over shaft assembly (12)
with seal down.
2. Slide long spacer (10) on shaft assembly.
3. Insert shaft assembly with bearing and spacer into
spindle housing from the bottom.
(Rev. 5/27/2005)
MAN0260 (8/6/2004)
CD6308
9. 3/8 NC x 1-1/2 HHCS
GR5
10. Spacer
11. Square key
12. Shaft assembly
13. Blade kit
14. Cup washer
15. 5/8 NF x 2 HHCS GR5
4. Install upper bearing (5) over shaft with the seal
facing up.
5. Install spacer (4) and sheave (3) over shaft.
6. Align keyways in shaft and sheave and insert key
(11).
7. Install washer (2), and bolt (1). Torque bolt to 35
lbs-ft.
8. Rotate sheave and check for free movement.
9. Lubricate spindle.
GEARBOX REPAIR
Read this entire section before starting any repair.
Many steps are dependent on each other.
Fill gearbox with SAE 80W or 90W gear lube until it
runs out the side level plug.
Repair to this gearbox is limited to replacing bearings,
seals, and gaskets. Replacing gears, shafts, and a
housing is not cost effective. It is more economical to
purchase a complete gearbox if repair to anything other
than replacement of bearings, seals or gaskets is
required.
Inspect gearbox for leakage and bad bearings.
Leakage is a very serious problem and must be cor-
rected immediately.
Bearing failure is indicated by excessive noise and side
to side or end play in gear shafts.

Seal Replacement

Recommended sealant for gearbox repair is Perma-
®
tex Aviation 3D Form-A-Gasket or equivalent.
Leakage can occur at the vertical or horizontal gaskets
and shaft seals.
Leakage at the horizontal gasket or seal can be
repaired without removing the gearbox from the mower.

Seal Installation

NOTE: Proper seal installation is important. An improp-
erly installed seal will leak.
1. Clean area in housing where seal outer diameter
(OD) seats. Apply a thin coat of Permatex.
2. Inspect area of shaft where seal seats. Remove
any burrs or nicks with an emery cloth.
3. Lubricate gear shaft and seal lips.
4. Place seal squarely on housing, spring-loaded lip
toward housing. Select a piece of pipe or tubing
with an OD that will sit on the outside edge of the
seal but will clear the housing. Tubing with an OD
that is too small will bow seal cage and ruin seal.
5. Carefully press seal into housing, avoiding
distortion to the metal seal cage.
Dealer Service 21