Table of Contents
Advertisement
APPENDIX B: ASSEMBLING LOUDSPEAKER CABLES
ASSEMBLING PHOENIX-TO-ECO-M LOUDSPEAKER CABLES
When connecting loudspeakers and power supplies equipped with combination of Phoenix and ECO-M connectors, you
need a Phoenix 5-pin female to ECO-M 7-pin female cable. The following procedure documents how to assemble this
cable.
Assembled Phoenix-to-ECO-M Cable
To assemble a Phoenix-to-ECO-M cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the
black, red, blue, and white wires by 0.275 inch.
1"
2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin male cable mount connector. Use the
following wiring scheme.
Pin Destinations for Phoenix 5-Pin Male Cable Mount Connector
3. Secure the conductors by tightening the five screws in the Phoenix cable mount connector. Screws should be torqued
to 5–6 Nm (4.4–5.3 In-Lbs).
CAUTION:
Screws should not be inserted into the Phoenix connector while the connector rests in a mating
plug. Doing so will damage the contacts. During assembly, the Phoenix connector should only be held in place
externally.
24
0.275"
Pin 5
White
Pin 4
Blue
Pin 3
Shield drain
Pin 2
Red
Pin 1
Black
screws
Audio signal (+)
Audio signal (-)
Audio shield
DC power (+)
DC power (-)
Advertisement
Table of Contents
