Switching The System On; Switching The System To Standby Mode; Switching The System To Eco Power Standby Mode; Power Saving Automatic Standby - Philips FW-i1000 Manual

Switching the system on

In Standby mode
Press STANDBY ON, CONNECT or CD/
TUNER/TAPE/AUX on the system.
The system will switch to the last selected
source or the selected source.
Press any one of the DISC 1/2/3 buttons or
OPEN•CLOSE.
The system will switch to CD mode.
In Eco Power Standby mode
Press CONNECT, CD 123, TUNER,
TAPE 1/2 or AUX/CDR on the remote
control.
The system will switch to the selected source.
Switching the system to Standby
mode
In Demonstration mode
Press and hold DEMO STOP Ç on the
system.
In Eco Power Standby mode
Press ECO POWER.
In any other source mode
Press STANDBY ON (or B on the remote
control).
The clock will appear on the display when the
system is in Standby mode.
Switching the system to Eco
Power Standby mode
Press ECO POWER (or press and hold B on
the remote control).
"ECO POWER" will be displayed, then the
display screen will go blank.
The low power ECO POWER LED will be
lighted.
Note:
– If you have not deactivated the demonstration, it
will resume five seconds after the system switches
to Eco Power Standby or Standby mode.
pg 001-036/i1000/37-Eng

Power Saving Automatic Standby

As a power-saving feature, the system will
automatically switch to Standby mode if you do
not press any buttons within 30 minutes after a
disc or tape has stopped playing.

Dim mode

You can select the desired brightness for the
display.
Press DIM repeatedly to select DIM 1, DIM 2,
DIM 3 or DIM OFF display mode.
DIM
OFF mode.
DIM OFF - normal brightness with
Spectrum Analyzer On
DIM 1 - normal brightness with Spectrum
Analyzer Off
DIM 2 - half brightness with Spectrum
Analyzer On
DIM 3 - half brightness with Spectrum
Analyzer Off and all LEDs on the system
will be switched off.
15
Basic Functions
appears on the display, except for DIM
3139 115 20831
4/20/01, 8:35 AM
15