Electrical Connections; Electrical Data - Wolf WKGHC ML-767590 Owner's Manual

Install right side panels on both ovens. Connect the piping between
the top oven and bottom oven. Pipe joint compound must be resistant
to the action of propane gases.
The manual gas valve at the bottom of the control panel should remain
off until all electrical connections are made and the ovens are checked
or used.
LEVELING
Once the oven is in its permanent position, place a carpenter's level
on the oven rack. If the oven is installed on legs, turn the adjustable
feet in or out to level oven front-to-back and side-to-side. If the oven
is installed on casters, loosen set screws and turn casters in or out to
level oven front-to-back and side-to-side. Retighten set screws after
leveling.

ELECTRICAL CONNECTIONS

Electrical and grounding connections must comply with the applicable portions
of the National Electrical Code and/or other local electrical codes.
Appliances equipped with a flexible electric supply cord are provided with a
three-prong grounding plug. It is imperative that this plug be connected into a properly
grounded three-prong receptacle. If the receptacle is not the proper grounding type, contact an
electrician. Do not remove the grounding prong from this plug.
The 120 volt models are equipped with a cord and plug.
Refer to electrical wiring diagram located inside the right side panel; remove control panel for access.
Do not turn the power supply on until after the gas connections have been made and checked for leaks.
Model Volts
WKGHD 200-240
208-240
WKGHC
200-240

ELECTRICAL DATA

Hertz
120 60
50
60
120 60
50/60
Minimum Circuit Ampacity
Phase Maximum Protective Device
1
1
1
1
1
– 6 –
CHIMNEY
LONG FLUE
EXTENSION
RIGHT ANGLED
FLUE EXTENSION
PL-52221
Fig. 4
AMPS
15
15
15
15
15