Electrical Connections; Assembling Stacked Ovens - Wolf WKE ML-126755 Owner's Manual

ELECTRICAL CONNECTIONS

WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT
SWITCH TO INDICATE THAT YOU ARE WORKING ON THE CIRCUIT.
Remove the wiring compartment cover on the front of the oven. Remove the appropriate knockout on
the bottom of the oven and attach the power supply conduit to the bottom of the oven.
Comply with the wiring diagram (located inside the right side panel) when making connections to the
electrical supply lines.
Replace the wiring compartment cover and turn on the power supply.
TOTAL 3-PHASE LOADING 3-PHASE LOADING
KW KW PER PHASE
L1-L2 L2-L3 L1-L3 L1-L2 L2-L3 L1-L3
Single Oven 12.5
Stacked Oven 25

ASSEMBLING STACKED OVENS

Unpack the ovens and the stack kit. Position
the oven to be used as the bottom oven on
its left side for access to the oven bottom,
taking care not to scratch or damage it.
Attach the four leg assemblies with the 24
bolts and lockwashers (6 per leg).
Place the lower oven (with legs) on the floor
7
and remove two ⁄
16
knockouts on each side of the top cover.
Install two locating studs to the bottom of the
top oven per stacking kit instructions.
Move the oven with legs to the installed
position. Place the upper oven on top of the
lower oven using the locating studs.
Remove the optional rear panel, if provided,
from the TOP oven. Install the Stacking Flue
(Fig. 3) with the four screws provided.
Replace the top oven rear panel, if provided.
ELECTRICAL DATA
208-240V 480V
KW PER PHASE
4 4 4.5 4 4
8 8 9 8 8
" (11 mm) diameter
NOMINAL AMPERES PER LINE WIRE
208V
L1 L2 L3 L1
4.5 35 33 35 33
9 70 66 70 66
– 5 –
3-PHASE
240V 480V
L2 L3 L1 L2 L3
29 33 14.4 15.3 15.3
58 66 28.8 30.6 30.6 120
STACKING FLUE
PL-53463
Fig. 3
1-PHASE
208V 240V 480V
60 52 26
104 52