Vehicle Lift And Support Locations - Toyota Corolla 2002 Repair Manual Supplement

BACK TO CHAPTER INDEX

VEHICLE LIFT AND SUPPORT LOCATIONS

1. NOTICE ABOUT VEHICLE CONDITION WHEN JACKING UP
(a) The vehicle must be unloaded before jacking up the vehicle. Never jack up/lift up a heavily loaded ve-
hicle.
(b) When removing heavy parts such as the engine and transmission, the center of gravity of the vehicle
may shift. To stabilize the vehicle, place a balance weight in a location where it will not roll or shift, or
use a mission jack to hold the jacking support.
2. NOTICE FOR USING 4 POST LIFT
(a) Follow the safety procedures outlined in its instruction manual.
(b) Use precautionary measures to prevent the free beam from damaging tires or wheels.
(c) Use wheel chocks to secure the vehicle.
3. NOTICE FOR USING JACK AND SAFETY STAND
(a) Work on a level surface using wheel chocks at all times.
(f) When jacking up only the front wheels or only the rear wheels, place wheel chocks on both sides of
the wheels touching the ground.
(g) When lowering the vehicle with its front wheels jacked up, release the parking brake and place wheel
chocks only in front of the rear wheels. When lowering a vehicle with its rear wheels jacked up, place
wheel chocks only behind the front wheels.
COROLLA Supplement (RM1129E)
To Alphabetical Index
To Sub Index
INTRODUCTION
Rubber Attachment
B84155
: SUPPORT POSITION, PANTOGRAPH JACK POSITION
: JACK POSITION
TOYOTA COROLLA REPAIR MANUAL SUPP 1129E
-- REPAIR INSTRUCTION
(b) Use a rigid rack with a rubber attachment, as shown in the
illustration.
(c) Apply the jack and rigid rack to the specified location on
the vehicle.
(d) When jacking up the front wheels, release the parking
brake and place wheel chocks only behind the rear
wheels. When jacking up the rear wheels, place wheel
chocks only in front of the front wheels.
(e) The jack should not be used without the rigid rack.
TO MODEL INDEX
01- -19
010XM--02
D27350