Advertisement
INSTALLATION OF THE HORIZONTAL AIR/FLUE DUCT (REAR OUTLET)
2
7
Fig. 3.9
1
Fig. 3.10
(TURBOMAX AND THERMOCOMPACT ONLY)
3
b
For thermoCOMPACT 615, 637 and
5
turboMAX plus 837:
• Remove two screws (2) and
• Swivel the collector hood (4)
• Extend the white air pressure tube
• Refit the retaining spring clip (5)
4
• Loosen the screw (9) and remove
• Reconnect the bracket into position
• Refit the flue gas connector (6) to
a
8
9
• Reconnect the electrical cables to
• Gently push the flue duct
• Slide the fan (2) into position on
3
• Secure the fan to the flue collector
4
2
• Reconnect the air pressure tubes to
4
Note: Blue tube connects to the rear
most fan outlet spigot.
• On combustion chamber cover
• Reassemble the boiler in reverse
• Complete the installation as
separate the fan from the collector
hood (4).
through 180° and locate back into
position in the appliance.
with the tube extension and nipple
provided.
on the top of the collector hood (4)
Remove blank and refit funnel.
the support bracket (8).
(b).
the fan (7) and secure.
the fan.
downwards to the left.
flue collector hood (3). Ensure that
the flue gas connector (1) engages
over the end of the flue duct and
the flange on the back of the fan
plate locks in to the collector
hood.
hood using the two screws (4).
the fan, ensuring that the air tubes
are connected to the correct
nipple.
front swap top left hand rubber
bung with the metal hole bung.
order.
detailed in the boiler Installation
and Servicing instructions.
19
Advertisement
