Digital club with 24-bit dual interface (29 pages)
Summary of Contents for Reloop MIXON 4
Page 1
RELOOP MIXON 4 FIRMWARE UTILITY SETTINGS Revision v2 (11/16) This document describes all available firmware settings for MIXON 4 which can be set on the device itself. MODES & SETTINGS: 1. LED Check Mode 2. Firmware Version Check 3. En-/Disable LED Stand-by Sequence 4.
Page 2
RELOOP MIXON 4 FIRMWARE UTILITY SETTINGS Revision v2 (11/16) 1. LED CHECK MODE 2. FIRMWARE VERSION CHECK Turn on all LEDs: Before you update your firmware, you can check whether the firmware version is already installed on the unit before proceeding. In case the displayed firmware version matches the downloaded firmware, no update is necessary.
Page 3
RELOOP MIXON 4 FIRMWARE UTILITY SETTINGS Revision v2 (11/16) 3. EN-/DISABLE LED STANDBY SEQUENCE 4. ACTIVATE VEGAS MODE (LED DEMO MODE) 5. FIRMWARE UDPATE MODE The standby sequence will start by default, if there is no The Vegas mode can be used for product presentations When a firmware update is available, the unit must enter operation for 10 minutes.
Page 4
RELOOP MIXON 4 FIRMWARE UTILITY SETTINGS Revision v2 (11/16) 6. ADJUST LED BACKLIT INTENSITY 7. ADJUST CROSSFADER CUT-IN All button LEDs have a backlight feature to ensure best performance and The crossfader CUT-IN (cut lag) can be adjusted on both sides of the crossfader in in- visibility in dark environments.