Advertisement
MOTION FEATURES
The remote's compass needs to be calibrated prior to using motion features to match alignment with the
calibrated ProNav Angler compass. Visit pronavmarine.com/calibration for a demonstration.
Calibrating the Remote:
1.
Rotate the remote three times along each axis.
2.
Wave the remote in a three-dimensional figure eight path as shown, keeping the remote parallel to
the path (similar to a car following a curved track). Extend the figure eight pattern out away from
you as long, wide and high as possible for an accurate calibration. Perform at least three figure
eight patterns to complete the calibration.
Drive PointDrive™ and PointJog™
PointDrive can be used to change heading while in GPS Vector or Compass Heading Mode. PointJog can
be used to change anchor location by 10' while in Anchor Mode.
How to Use PointDrive
1.
Press and release
while pointing the remote in the direction you want to go.
2.
Adjust GPS Vector or Compass Heading by pressing and releasing
direction.
Notes
•
PointDrive is not active for manual controls.
•
In GPS Vector Lock it may appear that the motor is steering in a direction different
than perceived current GPS Vector Lock direction. By checking the "Map View" screen on
the ProNav App you should see that your boat is actually following the current GPS Vector Lock
direction.
How to Use PointJog
1.
Press and release
while pointing remote in the direction you want to Jog. Anchor location will
move 10' in the direction you pointed.
Notes
•
This anchor change location can be verified by viewing anchor location on the "Map View" screen in
the ProNav App.
while pointing remote in new
Remote Calibration
PointDrive
PointJog
Jog distance
(default 10')
Advertisement
