Advertisement
SETUP AND CONNECTION
Watch video tutorials at: pronavmarine.com/getting-started
Device will be in "sleep mode" (low power state) upon arrival and will
have a full charge.
Note: If remote was purchased as a bundle with the ProNav Angler, it will
arrive paired to the ProNav Angler and Initial Setup step can be skipped.
Initial Setup
(network configuration required prior to first use)
1.
Open the ProNav App on your mobile device.
2.
Press "Connect"
in the lower left corner of App screen.
3.
Select "ProNav Central" from the device list that appears on App
screen.
4.
Select "Network Settings" in the Main App Menu
of App screen.
5.
Wake up remote by pressing the Bluetooth button
The remote will go into startup mode.
6.
Within 30 seconds of startup, hold the Bluetooth button
the remote until the blue indicator light starts blinking (indicating
connection mode).
7.
In the ProNav App press "Add Your ProNav Remote".
8.
Select "ProNav Remote" from device list.
•
Android Users: You are required to enter a desired name such as
"Remote 1" for your remote. To finish the pairing press "Set Remote".
•
iOS Users: You are not required to enter a name for your remote. To
finish the pairing hold down the Bluetooth button on your remote
until the blue indicator light flashes once then turns solid blue.
Remote is now paired to your ProNav Angler.
Turning Remote ON
1.
Press the Bluetooth button
mode.
2.
Once the remote is on any button press will be indicated by a
flash of the red indicator light.
3.
Remote will automatically turn off after 30 seconds if
"Connection to ProNav Angler" (step below) is not attempted.
Connection to ProNav Angler
completed)
1.
Within 30 seconds of startup, put remote into connection mode
in the top left
by holding the Bluetooth button
starts blinking.
on the remote.
2.
If you do not enter connection mode within 30 seconds of
startup, the remote will return to sleep mode. (Start process
on
over)
3.
Once connected the blue light will turn solid.
4.
Connection mode will time out after 2 minutes if not successful.
The remote will return to sleep mode. (Start process over)
Turning Remote OFF
1.
Press and hold the Mark
simultaneously until the red indicator light flashes quickly.
2.
During normal operation, remote will automatically turn off if
no buttons have been pressed within 1 hour.
(startup mode)
. The remote will go into startup
(after Initial Setup step has been
until the blue indicator light
(sleep mode)
and Rabbit
buttons
Advertisement
