Advertisement
ADVANCED FEATURES
Available in firmware versions 2.3 and newer.
Mark Spot
: When remote is connected to the ProNav Angler GPS (i.e. "ProNav Central" or "ProNav Hub"), pressing
saves current location, allowing it to be viewed in the ProNav App. Use of this button does not require the App be connected
to the ProNav Angler GPS—saved points will be stored until the next time the ProNav App is connected. Saved points func-
tion the same as "Anchor Points" in the ProNav App and can be viewed in the "Map View" screen of the App. Points can be
shown or hidden on the map from the "Anchor Point" menu and used for navigation.
Play/Pause
: While in route or anchor mode, pressing
will pause or resume current mode. Pausing the route or anchor
mode will stop motor and allow you to use the manual control functions (turn motor left / right, adjust thrust up / down, turn
prop on / off) to manually control motor. Resuming the route or anchor mode will reactivate GPS control and navigate back
to the position where boat was when the mode was paused.
Cruise Control
: When trolling motor prop is engaged in any of the following modes: heading lock, vector lock, or route
mode, pressing
will lock current GPS speed (minimum speed is 0.8 mph). Thrust will be automatically adjusted to main-
tain the set GPS speed. The set speed can be increased or decreased using the +/- buttons on the remote to adjust speed in
0.1 mph increments.
Advertisement
